8 GHz Tunable Gunn Oscillator in WR-137 Waveguide

Authors

  • P. C. Rakshit Institute of Radio Physics and Electronics, Calcutta
  • G Ghosh Institute of Radio Physics and Electronics, Calcutta
  • P. K. Saha Institute of Radio Physics and Electronics, Calcutta
  • B. R. Nag Institute of Radio Physics and Electronics, Calcutta

DOI:

https://doi.org/10.14429/dsj.33.6093

Keywords:

Coaxial mode, Gunn diode, Waveguide

Abstract

The conventional technique of realising waveguide resonators for Gunn diode oscillators to operate at the band edge of the waveguide fails owing to the excitation of a coaxial mode resonance formed by the post and the side walls of the waveguide. One of the solutions to the problem is to mount the diode in a ridged waveguide resonator. This has been demonstrated by constructing an 8 GHz Gunn oscillator using a single ridge in WR-137 waveguide.The steps in designing the oscillator system are also presented.

Author Biographies

P. C. Rakshit, Institute of Radio Physics and Electronics, Calcutta

Institute of Radio Physics and Electronics, Calcutta-700 009

G Ghosh, Institute of Radio Physics and Electronics, Calcutta

Institute of Radio Physics and Electronics, Calcutta-700 009

P. K. Saha, Institute of Radio Physics and Electronics, Calcutta

Institute of Radio Physics and Electronics, Calcutta-700 009

B. R. Nag, Institute of Radio Physics and Electronics, Calcutta

Institute of Radio Physics and Electronics, Calcutta-700 009

Downloads

Published

2014-01-31

How to Cite

Rakshit, P. C., Ghosh, G., Saha, P. K., & Nag, B. R. (2014). 8 GHz Tunable Gunn Oscillator in WR-137 Waveguide. Defence Science Journal, 33(1), 1–5. https://doi.org/10.14429/dsj.33.6093

Issue

Vol. 33 No. 1

Section

General Papers

License

 Where otherwise noted, the Articles on this site are licensed under Creative Commons License: CC Attribution-Noncommercial-No Derivative Works 2.5 India