Explosive Forming of Low Carbon Steel Sheet into a Stepped Disc Shape

Authors

  • S. Balasubramanian Defence Metallurgical Research Laboratory, Hyderabad
  • S. Sarvat Ali Defence Metallurgical Research Laboratory, Hyderabad
  • E.S. Bhagiradha Rao Defence Metallurgical Research Laboratory, Hyderabad

DOI:

https://doi.org/10.14429/dsj.34.7686

Keywords:

Explosive Forming, Stepped Disc Shape

Abstract

This paper deals with the explosive forming of deep drawing quality steel into a two stepped disc type shape. An attempt has been made to predict the forming parameters from theoretical considerations by equating the disc shape with an equivalent dome. Results of forming this shape in a single stage vis-a-vis forming in two stages are compared.

Downloads

Published

2014-05-30

How to Cite

Balasubramanian, S., Ali, S. S., & Rao, E. B. (2014). Explosive Forming of Low Carbon Steel Sheet into a Stepped Disc Shape. Defence Science Journal, 34(3), 235–256. https://doi.org/10.14429/dsj.34.7686

Issue

Vol. 34 No. 3

Section

General Papers

License

 Where otherwise noted, the Articles on this site are licensed under Creative Commons License: CC Attribution-Noncommercial-No Derivative Works 2.5 India