Integrated Computer Aided Planning and Manufacture of Advanced Technology Jet Engines

  • B. K. Subhas Gas Turbine Research Establishment, Bangalore
  • Chacko George Gas Turbine Research Establishment, Bangalore
  • A. Arul Raj Gas Turbine Research Establishment, Bangalore
DOI: https://doi.org/10.14429/dsj.37.5935
Keywords: CAD CAM, Jet engine, Manufacturing system

Abstract

This paper highlights an attempt at evolving a computer aided manufacturing system on a personal computer. A case study of an advanced technology jet engine component is included to illustrate various outputs from the system. The proposed system could be an alternate solution to sophisticated and expensive CAD/CAM workstations.

Author Biographies

B. K. Subhas, Gas Turbine Research Establishment, Bangalore
Numerical Control Technology Section, Gas Turbine Research Establishment, Bangalore-560075
Chacko George, Gas Turbine Research Establishment, Bangalore
Numerical Control Technology Section, Gas Turbine Research Establishment, Bangalore-560075
A. Arul Raj, Gas Turbine Research Establishment, Bangalore
Numerical Control Technology Section, Gas Turbine Research Establishment, Bangalore-560075
Published
2014-01-17
How to Cite
Subhas, B., George, C., & Raj, A. (2014). Integrated Computer Aided Planning and Manufacture of Advanced Technology Jet Engines. Defence Science Journal, 37(4), 483-488. https://doi.org/10.14429/dsj.37.5935
Issue
Vol 37 No 4
Section
Special Issue Papers
Copyright (c) 2016 Defence Science Journal

 Where otherwise noted, the Articles on this site are licensed under Creative Commons License: CC Attribution-Noncommercial-No Derivative Works 2.5 India