Fiberoptic Data Bus Interface Hardware Realisation
Keywords:
Bus interface circuit, Copper wire data bus, Biphase manchester modulation, Fiberoptic data bus, Data transmission
Abstract
Bus interface cirsuit for a fiberoptic data bus differs from a copper wire data bus. While unipolar manchester modulation is used with a fiberoptic data bus, a biphase manchester modulation is used in the copper wire data bus.
This paper suggests a design of a bus interface circuit for any fiberoptic data bus for fly-by-light, stores management, data transmission, etc., compatible with the MIL-STD-1553B. This is applicable for use on board aircraft, ships. tanks, etc.
Published
2014-01-13
How to Cite
Manoharan, L. (2014). Fiberoptic Data Bus Interface Hardware Realisation. Defence Science Journal, 38(2), 203-207. https://doi.org/10.14429/dsj.38.5880
Issue
Section
General Papers
Copyright (c) 2016 Defence Science Journal
Where otherwise noted, the Articles on this site are licensed under Creative Commons License: CC Attribution-Noncommercial-No Derivative Works 2.5 India