Design of Interface Hardware and Software for DNC System

Authors

  • I.K. Kaul Defence Research & Development Laboratory, Hyderabad.
  • D.R. Yadav Defence Research & Development Laboratory, Hyderabad.
  • J.P. yadav Defence Research & Development Laboratory, Hyderabad.

DOI:

https://doi.org/10.14429/dsj.44.4161

Keywords:

Distributed numerical control, Computer networks, Software interfaces, Computer aided design

Abstract

This paper describes in detail an indigenous state-of-the-art DNC system designed, developed, fabricated and installed at DRDL NC Centre. It describes the hardware and software interfaces designed and developed in-house. At present, it supports a total of 16 CNC machines, 8 in serial port and the balance in parallel port. This system has the capability of extension up to 64 machines. During last one year of its installation and working it has been found to be extremely reliable.

Author Biographies

I.K. Kaul, Defence Research & Development Laboratory, Hyderabad.

Defence Research & Development Laboratory, Hyderabad.

D.R. Yadav, Defence Research & Development Laboratory, Hyderabad.

Defence Research & Development Laboratory, Hyderabad.

J.P. yadav, Defence Research & Development Laboratory, Hyderabad.

Defence Research & Development Laboratory, Hyderabad.

Downloads

Published

2013-01-01

How to Cite

Kaul, I., Yadav, D., & yadav, J. (2013). Design of Interface Hardware and Software for DNC System. Defence Science Journal, 44(2), 139–146. https://doi.org/10.14429/dsj.44.4161

Issue

Vol. 44 No. 2: Computer Applications

Section

Special Issue Papers

License

 Where otherwise noted, the Articles on this site are licensed under Creative Commons License: CC Attribution-Noncommercial-No Derivative Works 2.5 India