Impact of Blowing Location on the Aerodynamic Characteristics Over the Delta Wing

Abstract

The performance of an aircraft can be enhanced by altering the flow field favourably by adopting flow control techniques. The present study deals with the application of the active flow control methods on a sharp-edged delta wing with a wing sweep of 65°. The concept of blowing was employed as an active flow control technique. The blowing technique is applied on the suction surface of the delta wing by varying its location. The various identified locations of the blowing holes are 1.62 %, 3.24 % and 4.86 % of root chord from the leading edge to the centre of the blowing holes. The computation is performed using the commercial software ANSYS Fluent. An unsteady, incompressible Reynolds-averaged Navier–Stokes equation and the shear-stress transport k-ω turbulence model are employed. The angles of attack varied in the range of 0°<α<35° and Reynolds number is 2.64×106 and the jet momentum coefficient is fixed at 0.05. The blowing of air from the injection region enhances the strength of the leading-edge vortices, resulting in a delay in the vortex breakdown. The performance of the delta wing is greatly improved while using the blowing method specifically for the blowing holes located at 3.24 % of root chord from the leading edge compared to without the blowing method.